My version of a strip till knife for conventional toolbars. Just got a few samples running for this fall. Foot angles and point width similar to a B33 mole, just a lot more meat to wear though. Freeze proof and tall cutting edge so the knife runs clean. Can’t make the knife any narrower due to wall thickness limitations of the casting.
1
30
2,407
The reality of 3D printing. You’ll probably have to work on your printer at some point. This is true of the 5 different models I’ve owned since 2020. My 7 Bambu X1E printers have printed 1000s of parts for me so I can’t complain.
3
491
The challenges of 3d printing nylon filaments. The print on the right is junk due to moisture in the filament. Foggy and rougher texture from the moisture. This will also make the part brittle. Filament dryer died after I started the print. When everything is dialed in these carbon fiber nylon parts are amazing.
2
5
1,824




























