@wireengineer

I like assembly (both types)

 Rochester, MN
Joined January 2012
  • Tweets6.3K
  • Following143
  • Followers1K
3.1KMedia
That feeling when you realize you have been doing dinner and anime with the group every week for more than a decade....
2
88
found something
1
1
140
Encoder is working but it does not show up on boot. Needs a hotplug to be detected for some reason. Good enough to start taking bus traces and emulating.
1
8
837
Things afoot
1
4
190
When you know from the factory it will not start....
2
74
And it's off the trailer. Let the cleaning begin
58
Believe it or not that was my first guess at center of gravity
1
68
And done for the day
32
Controls unwired and cabinet removed. Just the quill to remove before I have to get back into sketchy stuff.
54
Started disconnecting the control cabinet
2
65
Off to make questionable decisions
1
3
139
more replies
Sketchy not sketchy
1
1
66
Correction very. But ways look good
2
56
Y reassembled and adjusted. Just need to figure out scale mounting and lock screws
47
Table back on and y lead screw thrust bearings adjusted. Need to do the gib and rear bearing mount yet
1
58
Finished adulting early so got some more of the lathe assembled. X lead screw, gibs adjusted, and tailstock on. Future me will hate current me as one of the locking set screws on the gibs is rounded out.
1
59
Today's shop progress. Got the x scale, mounting brackets, and cable management back in. Wish I remembered to do this before mounting the motor. Unfortunately getting good at removing and installing the motor.
2
75
Attention @CypherCon attendees, independent contest announcement: First person able to display a arbitrary, stable image using the factory IO on this display wins it, Pi pico 2 logic analyzer and LED board driver card BYOPP edition (ran out of picos).
1
1
174
more replies
No winner this year but made some progress. (pioc logic analyzer helped a lot) if the latch line is held for long periods of time eventually the mystery chip will start shifting out data to the LED drivers 16 bits at a time and latch it. So it does function.
1
48
Still cannot control the data lines. Possibly there is some sort of command data cycle I am missing. More debug likely next year / just build a new control chip.
40
Load more